A fitting record is useful only when it still points to the exact pattern copy it describes. This paper workflow uses the tailored-trousers project as an example: identify the version, keep its inputs with it, and record the published piece-to-piece checks before cutting.
1. Why versions get mixed up
Printouts, a re-draft made from changed measurements, and test pieces in different fabric can leave several similar copies on the table. A version number needs more than a sequence: beside it, record which measurements were used, the generator settings, and the date. That identifies the paper copy; it does not make a fit judgement.
2. Give every change one version name
Change one thing per version. Write the version number on every printed piece and on its fitting-log entry. When you re-draft from changed measurements, keep the completed Trousers / pants measurement sheet with that version and write the sheet’s date or identifier beside the new version number.
Open the Trousers / pants measurement sheet3. Use the fitting log with the Trousers / pants preset
Use Pattern source and version to identify the source and exact printed copy. In Base size / measurements used, point to the dated Trousers / pants measurement sheet, and in Pattern version write the same label that is on every printed piece. Tick a Stage — toile, first or final — only for an actual fitting. The Trousers / pants preset also provides area ticks when they help locate a later fitting note. Read the Nastix Patterns Tailored Trousers project.
The sheet is blank by design. It separates a project and pattern source from the versioned fitting entry, then keeps the observation, recorded change, and later result in distinct fields.
Open the Trousers / pants fitting log4. Paper checks before cutting
The tailored-trousers project publishes these places where the six patterns have to agree. Record a paper check in an entry for that version before a toile: leave Stage unticked, write “paper check” and the outcome in What I observed, then use Change made to the pattern only if a later version records a change. When a check produces a number — the measured waist seam line plus overlap, or the chosen seam allowance — write that number beside the version label. Read the project’s full checks.
- Waistband length against the waist drafted to — Without darts, the drafted waist equals the measurement used and the waistband follows it directly. With darts, measure the waist seam line on the printed front and back with the darts closed, then add the closure overlap; that is the length the waistband must match.
- Zip length against the front rise — Place the fly piece on the printed trouser front. Check that the zip ends above the point where the crotch curve starts to turn.
- Pocket bag against the crotch seam — Compare the slant pocket bag width with the distance from its opening to centre front. A bag wider than that space will be caught in the crotch seam when the fronts are joined.
- Welt position against the back dart — This check applies only when the block has darts. Position the welt so its full width clears both legs of the back dart, not only the dart’s centre.
- Seam allowances, everywhere — Each of the six generators has its own seam-allowance setting and default. Choose one allowance and enter it in all six before comparing the pieces.
5. Keep the set together
Keep each printed version, its measurement-sheet reference, and its fitting log together. The first sewing paper-kit guide shows how the related pages can stay in one project set. Read the sewing project paper-kit guide.
What the log does not do
The log does not diagnose fit, choose a correction, or replace the project instructions. Paperka receives page choices only; nothing written on the sheet is sent to Paperka.